Lime Dissolver“Plus”tc \"Plus\"萊姆“ ”tc \"萊姆“ ”\"No Fume Scale Removertc \"No Fume ScaleRemover\"安全無煙水垢去除劑●Environmentally Safe, Industrial Strength安全，高效●Non Corrosive for Stainless Steel andCeramic 對不銹鋼、陶瓷等無腐蝕●Application Wide Range 使用面廣泛●Can Be Used in Panel Heat Exchanger 可用于板式換熱器等較精密系統tc \"安全無煙水垢去除劑\"萊姆“ ”相對市面上絕大部分酸性清洗劑更安全、有效；采用特殊配方可用于去除各種無機鹽污垢，如水垢、銹漬、水泥漬以及石灰漬等轉化為水溶物后徹底清除；對不銹鋼、陶瓷等無腐蝕。特別適合用于去除如空調熱交換器設備等要求相對較高的清洗。Lime Dissolver“Plus”is much safer and more effective than mostof other acidic cleaner in market, it uses special ingredients which make itcan remove all kinds of scaling andfouling formed by inorganic salts. Such as water scale、rust、cement and Lime besmirch. Moreover, it doesnot corrode stainless steel and ceramic materials. It is especially applicable tothe high requirement of cleaning progress, for instance the air conditioning`scleaning and heat exchanger`s cleaning.使用方法1． 1.可通過沖刷或浸泡系統以去除不牢固的銹垢及污垢。2.對主機清洗，按1：5-15的比例配制清洗液。3.tc \"4.注入萊姆“ ”，運行一段時間后，會發現PH值較投放初期明顯變高;\"對系統打循環：若是主機清洗，循環時間在4-8小時左右。2． 4.tc \"5.對系統打循環：若是主機清洗， 循環時間在4-8小時左右；\"在排除廢液以前，請用酸洗中和劑中和至pH值7-8，這樣可確保排放污水達到國家排放標準。3． 5.tc \"6.在排除廢液以前， 請用氫氧化鈉或蘇打粉中和至7-8，這樣可確保排放污水達到國家排放標準;\"用清水徹底沖洗系統1-2次，以去除所有殘留。4． 6.tc \"7.用清水徹底沖洗系統1-2次，以去除所有殘留;\"注滿清水后，定期加入康星緩蝕阻垢一體劑和微生物殺滅劑，以便保養系統。Directions1. Remove the Loose scaling and fouling byscouring or immersion.2. Clean host machine using a working fluid atratio of 1:5~1:15.3. Clean host machine during the systemcirculating, the cleaning time should be 4~8h.4. Using a Neutralizer to adjust pH value of the Residual Liquid to 7~8 before waste water`s discharge, so it can come up to nationalstandard.5. Using water cleaning the system 1~2 timesto remove the residues.6. After water injection, add a certainquantity of ComStar Single Packed Scale and Corrosion Inhibitor and AlgaeDestroyer to maintain the equipment.tc\"8.注滿清水后，定期加入康星緩蝕阻垢一體劑和微生物殺滅劑，以便保養系統。\"注意：鋁制品表面慎用，大理石表面禁用。Attention: Careful Use in Aluminum Products ,Banned for Marble.注意事項1．操作時請戴橡膠手套和防護眼鏡。2．如不慎誤服，請立即漱口，并飲用大量牛奶或清水。